McAfee SG310, Руководство администратора

Страница: 110 / 412

110 McAfee UTM Firewall 4.0.4 Administration Guide
Network Setup menu options
Routes
1
From the Network Setup menu, click Network Setup, and select the Routes tab. The Static Routes
tab appears ( Figure 110 ).
Figure 110 Static Routes
2
Click New. The Static Routes edit page appears ( Figure 111 ).
Figure 111 Static Routes edit page
3
To add to the static route to the route table of the system, select the Enable checkbox. This checkbox is
enabled by default.
4
[Required] Enter the IP address in the Target Address field.
5
[Required] Enter a value in the Subnet mask field that identifies the destination network or host. A
subnet mask of 32 identifies a host route.
• Accepted value range: A number between 0 and 32.
• Can also be in the form 255.255.255.0.
6
[Optional] You can specify an Interface out which the network traffic should be routed from the Interface
list. Only current, valid interface configurations can be selected. This field generally only needs to be
specified if the target is directly connected to this appliance or if the target is on the remote end of a PPTP
or L2TP link. Available options are:
• None
• Currently configured connections
7
[Optional] Enter a Gateway Address through which the network traffic should be routed.
8
[Required] Enter a value in the Metric field that represents the metric of this connection. This generally
only has to be set if two or more routes conflict or have overlapping targets.
• Accepted value range: A number equal to or greater than 0.
9
Click Finish. The new static route appears in the Static Routes list ( Figure 112 ).