MBS HELLIA, Инструкция по установке и эксплуатации

Страница: 8 / 38

INSTRUCTIONS FOR INSTALLATION AND USE
3.6. Technical Information
The table shows technical information for three stove models - 8kW.
MODEL HELLIA
Dimensions (HxWxL) mm 1000x520x560
Chimney connection mm On the back side Ø80
Height from the floor to the flue connection axis mm 220
Voltage (50Hz) V 230
Electrical part power W 550
Stove power kW 8
Utilization degree % 90
Weight kg 120
CO emission reduced to 13% O2 % 0.02
Output gas temperature °C 140
Fuel Pellet
Pellet storage capacity (depending on the pellet) kg 15
Min consumption kg/h
0.8
Max consumption kg/h 1.9
Required draft Pa 2-12
IMPORTANT!
It is preferable to use a U.P.S.
(Uninterruptible Power Supplies – minimum 600W sine wave rectifier) to avoid problems in
case of power failure.
Damage due to power failure or large fluctuations in the supply voltage is not covered by the warranty!
4. SAFETY DEVICES
The stove is equipped with sophisticated safety devices
that stop the operation of the stove in case of unforeseen
situations, thus preventing all consequences that may be
caused by improper operation of the stove.
In any case, when a problem occurs, the devices will
stop adding pellet and the phase of stove shutting down
will begin. This will be manifested by a corresponding
alarm on the display (more details in the "Alarms"
section)
.
5. STOVE POSITIONING AND INSTALLATION
5.1 Environment
Positioning the stove is key to successful heating.
Before you decide where to position the stove, you
must consider the following:
• The stove is connected to voltage of 230V/50Hz.
• The connection location must be determined in
accordance with the requirements of the power
distributor and the current regulations.
• The power cable must be uninterrupted and free of
damage, must not pass over heated parts of the
stove or over other devices that may damage it.
• The load-bearing capacity of the floor where the
stove is installed must be sufficient to withstand the
weight of the stove.
• Combustion air cannot be obtained from closed rooms
(garages) or from rooms without ventilation. Ventilation
must be provided so that fresh air, which is needed for
combustion, reaches the stove.
• It is not recommended to install the stove in a bedroom,
bathroom or a room intended for storage.
• If the stove is installed on a wooden floor, it is
recommended to install a protective plate (glass,
aluminum sheet) that exceeds the dimensions of the
stove, 10 cm on the side and 30 cm on the front.
• It is best to install the stove in the largest room in the
facility in order to fully utilize the stove.