MBM FC 10 PLUS, Руководство по обслуживанию

Страница: 68 / 74

67
13.9 Stacker does not work.
Check external
conditions
Back door is open.
Close the back door.
SWING/5 lamp is not lit.
Set the SWING mode ON.
Ў
It works if stacking table is removed.
Set the stacking table properly.
Ў
Remove the cover on
the operator side and
check the working
status while setting
the TEST mode.
DC24V cannot be detected between pins
1 and 3 of the operation circuit board
CN-10. The switching power supply is faulty.
Ў
Motor emits sound when the SWING key
is pressed.
Loosening of mechanical part.
Ў
DC24V cannot be detected between pins
3 and 4 of the operation circuit board
CN-12 while the SWING key is pressed. The MAIN PCB is faulty.
Ў
DC24V cannot be detected between pins
1 and 2 of the swing relay connector
while the SWING key is pressed. Check the motor harness.
Ў
Resistance value of swing motor is
between 50 and 150 ohm.
The MAIN PCB is faulty.
Ў
Swing motor is out of order.
13.10 Eject lamp remains lit.
Check exterior
conditions
Stacking table is full.
Remove the paper.
Ў
It lights out if the stacking table is
removed.
The stacking table is not properly set.
Check if the machine is installed on a level floor.
Ў
The machine is exposed to direct sunlight.
Place the machine at a different place. Take an
appropriate measure to shield it against the direct
sunlight.
Ў
Clean the full stacking sensor.
Full stacking sensor is defective.