Mazda MAZDA5 2006, Руководство по установке, Страница: 3 / 20

3
1030658 Rev.A 09/05
DIPOLE ANTENNA MOUNTING
1. Remove the following components
a. Remove the driver’s side A-pillar panel being careful not
to damage the retaining clips or the curtain airbag. Care-
fully pull the rubber weather seal away from the door jamb
(FIGURE J) then, starting at the top of the panel, pull the
A-pillar panel toward the inside of the car but
DO NOT try
to pull all the way off. There is a white clip at the top which
only releases about an inch then the panel must be slid
off of it by pulling upward.
Be very careful not to damage
the head liner or break the white top clip.
b. Push the white top clip back into the A-pillar half way un-
til it rotates freely.
c. Turn the white top clip diagonally and pull straight out of
the A-pillar. (FIGURE K)
d. Slide the removed white clip into position on the A-pillar
panel. (FIGURE L)
2. Clean mounting spot with an alcohol pad prior to mounting.
Mount the dipole antenna to the windshield 210mm to the
right of center on the windshield, directly below the black wind-
shield trim material. (FIGURE M)
3. Run the antenna wire above the headliner to the driver’s A-
pillar, using a fiber stick to secure under the headliner.
Note: Make sure the antenna wire is secure under the head
liner, if necessary remove the sun visor to secure.
4. Route the antenna wire down the A-pillar securing it to the
existing wiring using (3) supplied tie wraps. Do not secure it
directly to the sunroof drain tube or airbag. (FIGURE N)
5. Route the antenna wire behind the left side of the dashboard.
The antenna will be connected to the remote start control
module later.
6. Re-install the driver’s side A-pillar panel and re-install the
weather seal along the A-pillar.
2
FIGURE K
FIGURE J
FIGURE L
FIGURE N
FIGURE M