Mazda 2010 Mazda6, Руководство пользователя

Страница: 179 / 516

If the warning light illuminates again even
after the tire pressures are adjusted, there
may be a tire puncture. Replace the
punctured tire with the temporary spare
tire (page 7-6).
NOTE
A tire pressure sensor is not installed to the
temporary spare tire. The warning light will
flash continuously while the temporary spare
tire is being used.
Warning light flashes
When the warning light flashes, there may
be a system malfunction. Consult an
Authorized Mazda Dealer.
q
System Error Activation
When the warning light flashes, there may
be a system malfunction. Consult an
Authorized Mazda Dealer.
A system error activation may occur in
the following cases:
l
When there is equipment or a device
near the vehicle using the same radio
frequency as that of the tire pressure
sensors.
l
When using the following devices in
the vehicle that may cause radio
interference with the receiver unit.
l
A digital device such as a personal
computer.
l
A current converter device such as a
DC-AC converter.
l
When excess snow or ice adheres to
the vehicle, especially around the
wheels.
l
When the tire pressure sensor batteries
are exhausted.
l
When using a wheel with no tire
pressure sensor installed.
l
When using tires with steel wire
reinforcement in the side walls.
q
Tires and Wheels
CAUTION
When inspecting or adjusting the tire
air pressures, do not apply excessive
force to the stem part of the wheel
unit. The stem part could be
damaged.
Changing tires and wheels
The following procedure allows the
TPMS to recognize a tire pressure sensor's
unique ID signal code whenever tires or
wheels are changed, such as changing to
and from winter tires.
NOTE
Each tire pressure sensor has a unique ID
signal code. The signal code must be
registered with the TPMS before it can work.
The easiest way to do it is to have an
Authorized Mazda Dealer change your tire and
complete ID signal code registration.
When having tires changed at an
Authorized Mazda Dealer
Tire pressure sensor ID signal code
registration is completed when an
Authorized Mazda Dealer changes your
vehicle's tires.
When changing tires yourself
If you or someone else changes tires, you
or someone else can also undertake the
steps for the TPMS to complete the ID
signal code registration.
1. After tires have been changed, switch
the ignition ON, then back to ACC or
off (LOCK).
2. Wait for about 15 minutes.
Driving Your Mazda
Starting and Driving
5-31
Mazda6_8AS2-EC-09E_Edition1 Page181
Monday, June 1 2009 3:58 PM
Form No.8AS2-EC-09E