Page: 9 of 10
11/5/2012
Inspection
When the battery is disconnected, the DSC may stop operating.
(The DSC OFF indicator will flash at this time, and the TCS/DSC operation indicator will illuminate.)
1. Turn the ignition switch to “OFF” and then turn it back to “ON”.
2. Turn the steering wheel clockwise as far as it will go, and then turn it back counterclockwise as far as it
will go.
3. Check that the TCS/DSC operation indicator is turned off.
4. Turn the ignition switch to “OFF” and then turn it back to “ON”.
5. Check that the TCS/DSC operation indicator is turned off. If the TCS/DSC operation indicator is still
illuminated or the DSC indicator is not turned off when the ignition switch is turned back to “ON”, contact
your Mazda dealer.
CAUTION
!
If the battery is disconnected, the power windows may no longer fully open or fully close
automatically.
1. Turn the ignition key to the “ON” position.
2. Press the power window switch to fully open the power windows.
3. Lift up the power window switch to fully close the power windows, and keep it pulled up for approximately
2 seconds.
4. Position the engine switch at “OFF”, and then at “ON” again. When the function doesn’t work after these
procedures, please contact your Mazda dealer.
CAUTION
!
Inspection Parts
Inspection Items (O)
Clearance / Fit
Scratches / Dirt /
Harness Interference
Installation /
Tightening /
Engagement
Operation Check
Negative battery terminal
O
Driver-side Door Seal
O
O
O
Driver-side A-pillar Trim
O
O
O
EC mirror torx screw
*1 O
EC harness connector
O
O
O
EC mirror features:
- Auto-dimming
*2 O
- Compass display
*3 O
- HomeLink
®
*4 O
User guide
*5 O
O : Applicable
*1: Tightened to 15 lb-in (18 kg-cm)
*2: Mirror dims (key must be in ON position).
*3: Displays either “C” or directional heading (key must be in ON position).
*4: Red LED illuminates when each button is pushed (test with key in the OFF position).
*5: In vehicle glove-box.
If the battery is disconnected, the TPMS (Tire Pressure Monitoring System) initial setting is
reset and the system may not operate normally.
1. Adjust the tire pressure (verify tire pressure using label on body side with driver’s door open).
2. Turn the ignition switch to the “ON” position.
3. Press the TPMS (SET) switch (long-press it until TPMS warning light in meter flashes two times and a beep
sounds one time).
4. Turn the ignition switch to “OFF.”
5. If the TPMS warning light illuminates or flashes even though the above procedure has been performed, contact
an Authorized Mazda Dealer.
CAUTION
!
