Page: 4 of 10
11/5/2012
d) Move the hook in the direction of arrows (1) and (2) using a Flat-
head screwdriver and detach it from the A-pillar inner panel.
(Fig.
1-4)
e) Remove the grommet in the direction of the arrow (3).
(Fig. 1-4)
f) Install new supplied A-pillar tether clip into A-pillar before proceed-
ing.
6. Remove OE Mirror.
a) Using a #T20 Torx, loosen the mirror mounting bracket screw.
(Fig.
1-5)
b) Grasp mirror mount at the tube, and gently pull upwards parallel to
the windshield to carefully slide mirror off windshield button.
1.
Attach EC mirror.
a) Hold the mirror head and slide the mount downwards as far as pos-
sible over the windshield button, until fully seated.
(Fig. 2-1)
b) Using a #T20 Torx, tighten the mirror mounting bracket screw to 15
lb-in.
1.
Plug EC harness connector into back of mirror. (Fig. 3-1)
Fig. 1-5
DO NOT rotate mirror, turn mirror side to side, or pull mirror away from
the windshield. Rotation, side to side movement, or pulling of mirror on
windshield button could damage or break the windshield and button,
requiring windshield replacement.
CAUTION
!
FLATHEAD SCREWDRIVER
Fig. 1-4
A-pillar connector must be replaced with the supplied tether clip.
!
NOTE
Fig. 2-1
Fig. 3-1
TORQUE SPEC.
15 lb-in (18 kg-cm)
EC Mirror Installation
Route EC Harness to Vehicle Power
