Disassembly Procedures
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors
before following any disassembly procedure.
WARNING
!
22
16021520 Rev. 0
©2002 Maytag Appliances Company
Removal of H.V. Transformer, Capacitor,
Diode (Rectifier), Magnetron
1. Remove outer case. Ground magnetron terminals to
magnetron housing with an insulated handle
screwdriver by touching the metal shaft first to the
magnetron housing, then to the magnetron tube
terminals.
2. Remove component mounting screw(s) and
disconnect wiring.
NOTE: When replacing H.V. components, route H.V.
wires at least
1
/
4
" from all grounded surfaces to
prevent arcing.
Removal of Outer Case Foot
CAUTION
!
To avoid possible excessive leakage it is mandatory
the Amana part number A4539625 rivet be used to
mount the unit feet. Do not substitute any other part.
1. Disconnect power to oven.
2. Place oven on its back and remove the plug button
from center of the foot with a small screwdriver.
Foot
Rivet
Plug button
3. Drill out rivet (Amana part number A4539625) to
remove the foot.
Blower Motor or Wheel
NOTE: Blower wheel has a "D" type hole in hub and clip
on end of motor shaft.
1. Disconnect power to oven.
2. Remove outer case.
3. Disconnect wiring from blower motor.
4. Remove screw from metal scroll bottom to partition.
5. Remove screws from base pan bottom to plastic
scroll legs.
6. Slide scroll discharge snout from partition and lift
scroll assembly from unit.
7. Unsnap metal bottom from scroll.
8. Remove blower wheel clip and wheel.
9. Remove motor mounting screws from scroll.
10.Reverse procedure to reassemble.
Blower
motor
Blower
scroll
Blower
wheel
Push
clip
Scroll
bottom
bracket
Splatter Shield
NOTE: Be careful not to bend antenna when removing
splatter shield. Shield snaps into a lip in front of
the oven and three slots in the back.
1. Place your thumbs in the two indentations in front of
the shield.
2. Press lightly towards the back and carefully lower
shield away from antenna.
3. Pull shield out of the back slots and out of the oven.
Splatter
shield
Antenna and Cradle
NOTE: Antenna assembly is mounted in a cradle. The
antenna is located on a tower in the middle of
the cradle.
1. Remove outer case and splatter shield.
Содержание 1324704M
Страница 4: ......
Страница 40: ...2002 Maytag Appliances Company 16021520 Rev 0 B 1 Appendix B...