Maytag 1324704M, Сервисная инструкция

Страница: 22 / 42

Disassembly Procedures
To avoid the risk of electrical shock, personal injury, or death,
disconnect power to oven and discharge the capacitors
before following any disassembly procedure.
WARNING
!
©2002 Maytag Appliances Company
16021520 Rev. 0 21
Outer Case Removal
1. Remove screws securing outer case to the oven.
2. Pull back on outer case and lift off.
CAUTION
!
During disassembly some foam gaskets may require
removal. These components must be replaced for
proper circulation of air over the components and
through the oven cavity.
Start Switch and Button (some models)
1. Remove outer case to gain access to switch.
2. Disconnect wires from switch.
To remove button and start switch assembly:
3. Remove escutcheon.
4. Remove dial knob to release thinplate.
5. Using caution to prevent damage to indicator light,
carefully rotate thinplate counterclockwise to gain
access to start button and to the screws securing
start switch assembly.
6. Reverse procedures to reassemble.
Control Assembly (painted models)
1. Disconnect power to oven and open door.
2. Using the Amana R0193557 escutheon removal tool,
insert the right angle edge under the left side of the
control escutcheon 1.5" from top and carefully pull
back to release tabs from control assembly.
3. Remove screws securing control assembly to oven.
4. Disconnect wiring attached to control assembly
components.
5. Reverse procedure to reassemble.
Escutcheon
Escutcheon
removal tool
Timer
control
assembly
Control Assembly (stainless steel models)
1. Disconnect power to oven.
2. Insert small bladed screwdriver in the service slot.
Push down on the retainer clip and tilt escutcheon
forward, lift, and remove.
NOTE: Removal of outer case will facilitate removal of
timer wiring and components, but is not
necessary in all cases.
Escutcheon
Timer
control
assembly
Escutcheon
bracket
Service
slot