12
Maintenance and Care
CAUTION
Before starting cleaning, maintenance and / or repair work, the exerciser must be completely disconnected from
the power supply. This will only be the case if the mains cable is disconnected from the power socket and from
the training device. Therefore, first disconnect the electrical plug from the power socket, and then disconnect the
mains cable from the exerciser. The mains cable may only be reconnected to the training device and the power
supply when all work has been completed and the proper functional condition of the device has been restored.
Cleaning
Clean your training device after each workout. Use a damp cloth and soap. Never use solvents. Regular clean-
ing contributes significantly to the preservation and longevity of your training device. Due to the chemical com
-
position of body sweat, this is the main cause of corrosion (rust) if not removed immediately. Therefore, after
every training session, check whether body perspiration and / or other fluids have got onto the device. If this is
the case, the affected components / housing parts must be cleaned.
Please note
that damages caused by body sweat or any other liquids are not in any way covered by the war-
ranty.
During training, make sure that no fluid can enter the training device or the computer.
Maintenance
Checking the fastenings
Check the tightness of nuts and bolts at least once a month and re-tighten if necessary.
Lubricating the sliding tubes
The top of the sliding tubes must be cleaned and lubricated regularly. Clean the sliding tubes with a damp cloth
and some liquid hand soap or detergent. For professional cleaning we recommend the MAXXUS® Degreaser
Spray. Then dry the sliding tubes thoroughly and lubricate the top of the tubes with liquid silicone or MAXXUS®
lubricant spray to form a thin layer.
With frequent use, you should clean and lubricate the sliding tubes once a week. Lubricate the sliding tubes im-
mediately if squeaking sounds occur during training. Care and cleaning agents are available in our online shop
at www.maxxus.com or in our showroom in Weiterstadt.
Lubricating the axles on the handlebar stem and on the drive discs
The two transverse axles on the handlebar stem, and the axles on the large drive discs, should be lubricated
once every 6 months with multipurpose grease - please refer to the appropriate section in this manual.
Make sure your exercise equipment is always level. In order to compensate for minor bumps or slopes in the
floor, adjustable feet are fitted on the right and left of the front and rear stands and on the sliding frame. To make
sure the position of the device is level, first turn all feet to the lowest position (position A). If necessary, adjust
the feet until the device is level and stable.
If the adjustment range of the levelling feet is not enough to allow the training device to stand safely, please
check the surface of the location and, if necessary, choose a different location, where a safe and level position
can be ensured.
Levelling the Device
Adjustable foot
Adjustable foot
Adjustable foot
Adjustable foot
Position A
Position B
