______________________________________________________________________________
Page 34
ANNEX – CONNECTION TO A PC-
• Direct connection via mini USB cable
1. In order to establish a connection to the sampler, the Maxxware Connect Software
has to be installed
first
(see installation remarks on next page).
2. Thereafter the sampler can be connected directly to a PC by means of a standard
mini USB interface.
3. Select „USB“ as connection type in the connect software.
• IP connection via RJ45 cable
1. Setting of ports:
Pay attention that the ports are set correctly when establishing a network connection:
-
http
à
Port 80
-
ftp
à
Port 21
-
telnet
à
Port 23
If a DHCP server is not available, the default IP is:
192.168.60.8
2. Check the IP address at the sampler
In case of an operation in a local network, the IP address is received via DHCP or can be
permanently set if necessary. The IP address can be displayed on the sampler display in the
menu “DIAGNOSTICS/TEST", "IP ADDRESS".
3. Direct connection of a Notebook/PC at the sampler via RJ45 cable
(only possible with installed WEB board)
For direct connection the IP address at the PC has to be set in the range of 1 – 254, except
the number 8, for example: 192.168.60.
9
Now, enter the following login data at the PC under „Network connection „ -> „LAN
connection“ -> „Properties“->“ Internet protocol version 4 (TCP/IPv4)“-> „Properties“->Use
the following IP address“->
IP address:
192.168.60.
x
(x = 1 - 254,
except
8
)
Subnet mask:
255.255.255.0
Standard gateway: not required
