Maxx Ice MIM250, Руководство по обслуживанию, установке и инструкция

Страница: 15 / 56

SERVICE AND INSTALLATION MANUAL
www.maxxfoodservice.com
Cleaning and Maintenance
DO NOT use solvent-based cleaning agents or abrasives on the interior
These cleaners may transmit taste to the ice cubes, or damage or discolor
the interior
WATER DISTRIBUTION TUBE CLEANING
When you find that the ice cubes are incompletely formed or the output of ice cubes is low, the water
distribution tube may be blocked Set the power switch to OFF Unscrew the six screws holding the top
panel and remove the panel You will see the water distribution tube Rotate the water distribution tube
so that the holes in it are facing up Using a toothpick or similar tool, dredge the holes, then rotate the
water distribution tube back to its original position If the tube is badly blocked, clean it as follows:
1 Shut off the water and power supplies
2 Disconnect the water hose from the distribution tube
3 Lift one side, remove the distribution tube
4 With a brush, clean the tube with a dilute solution of warm water and a mild detergent such as
dishwashing liquid After removing the dirt and lint from the surface, rinse the tube with clean water
5 Replace the distribution tube
6 Reconnect the water supply and power supply lines
7 Re-attach the top panel
ICE-MAKING SYSTEM CLEANING
Minerals that are removed from water during the freezing cycle will eventually form a hard, scaly
deposit in the water system Cleaning the system regularly helps remove the mineral scale buildup How
often you need to clean the system depends on how hard your water is or how effective your filtration
may be With hard water of 15 to 20 grains/ gallon (4 to 5 grains/liter), you may need to clean the system
as often as every 3 months
1 Set the power switch to OFF
2 Remove all ice cubes from the storage bin
3 Keep the ice maker connected to the water supply Pour 8 oz of Nickel-Safe Ice Maker Cleaner
Solution into the water tank
4 Turn the power switch ON Within 3 minutes, press the CLEAN button The machine will run the
Automatic Clean mode The green Ice Making and the yellow Ice harvest LEDs will blink
5 The cleaning cycle will continue for 30 minutes unless you press the power switch (you can press the
power switch to stop the cleaning cycle any time during the 30 minutes) After cleaning, the green
Ice Making and yellow Ice Harvest LEDs go on steady and the machine returns to Stand-by mode
6 The dirty water must be drained out completely Perform steps 2 and 3 in the Interior Cleaning section
7 Repeat steps 1 to 6 above three times to rinse the ice-making system completely NOTE: Do not add
Ice Maker Cleaner Solution to the water trough during the rinses
8 If you want to make ice cubes after cleaning, turn off the power switch, drain off the waste water,
then turn on the power switch The next ice-making cycle will begin
9. Discard the first batch of ice.
DANGER
WARNING
CAUTION
14