Cleaning and Maintenance
Sanitizing the Ice-Making System
1 Set the power switch to OFF
2 Remove all ice cubes from the storage bin
3 Prepare a sanitizing solution by mixing 1 oz household bleach with 1 gallon of warm water
4 Keep the ice maker connected to the water supply Fill the water tank with the sanitizing solution
5 Turn the power switch ON Within 3 minutes, press the CLEAN button The machine will run the
Automatic Clean mode The yellow Ice Harvest and the red Bin Full LEDs will blink
6 The cleaning cycle will continue for 30 minutes unless you press the power switch (you can press the
power switch to stop the cleaning cycle any time during the 30 minutes) After cleaning, the yellow
Ice Harvest and the green Ice Making LEDs go on steady and the machine returns to Stand-by mode
7 The dirty water must be drained out completely Perform steps 2 and 3 in the Interior Cleaning section
8 Repeat steps 4 to 7 above three times with fresh water to rinse the ice-making system completely
NOTE: Do not add any cleaning or sanitizing solution to the water trough during the rinses
9 If you want to make ice cubes after cleaning, turn off the power switch, drain off the waste water,
then turn on the power switch The next ice-making cycle will begin
10. Discard the first batch of ice.
The ice machine cleaner contains acids
DO NOT use or mix with any other solvent-based cleaner products
Use rubber gloves to protect hands Carefully read the material safety
instructions on the container of the ice machine cleaner
DISCARD the first batch of ice produced after cleaning.
Control Panel
(located at the left side of front bottom louver panel)
Push the control panel cover to open it The control
panel includes one power switch, two button and
four indicator lights
OPERATION OF THE CONTROL PANEL:
1 When the unit is plugged in and the power switch
is turned on, the power indicator and the other
three indicator lights are all on
2 After 3 minutes for water inlet, the ice machine
will start to make ice automatically Only the
power and ice-making indicators will be on
3 During harvesting, the harvest indicator light is on
and the ice-making indicator is off When the ice
storage bin is full, only the ice-full indicator and
power indicator are on
4 If the Clean button is pressed during the ice-making mode, it will be ignored The ice-making
will continue
5 When you want to clean the machine, turn off the power switch first, then turn it on again. Press the
Clean button within 3 minutes and the ice maker will start the cleaning mode, with harvest and ice-
making indicators blinking After 30 minutes, the cleaning mode stops and the harvest indicator and
ice-making indicators are on steady If you want to restart the ice-making process after cleaning, turn
off the power switch first and drain the waste water, then turn on the power switch again and the
machine will automatically go into the ice-making process
6. If you want to interrupt the cleaning mode before it is finished, do not press the Clean button again.
Instead, turn the power switch off This stops the cleaning mode
DANGER
WARNING
CAUTION
15
Содержание MIM250
Страница 19: ...SERVICE AND INSTALLATION MANUAL www maxxfoodservice com NOTES 18...
Страница 37: ...MANUEL D UTILISATION ET D INSTALLATION www maxxfoodservice com NOTES 36...
Страница 55: ...MANUAL DE SERVICIO E INSTALACI N www maxxfoodservice com NOTAS 54...
Страница 56: ...3355 Enterprise Ave Suite 160 Ft Lauderdale FL 33331 T 954 832 3724 F 954 202 7337 www maxxfoodservice com...