31
Operating Instructions
2.
Rotate
Control Dial
to select PROGRAM 1 and press
Control Dial
.
You can now setup Program 1.
3.
Press
Mode Switch Button
to switch between the 8 Time Points.
4.
Rotate
Control Dial
to select ON/OFF.
This will activate or deactivate this Time Point. When a Time Point has been deactivated,
the settings associated with this Time Point will be ignored, but not deleted. You could use
this feature to quickly alter your photoperiod without having to reprogram the settings.
5.
Press
Control Dial
to switch to the timer, rotate
Control Dial
to
change it.
The timer will increment/decrement in 30-minutes intervals. Note: Changes you made to
a Time Point will affect all subsequence Time Points to prevent erroneous behavior. For
example, if you change the timer to a larger value than the next Time Point, the system
will push the next Time Point to the same time, with a maximum value of 23:30.
6.
Press
Control Dial
to switch to Channel A.
7.
Rotate
Control Dial
to adjust brightness for this channel then press
Control Dial
to switch to the next channel.
Repeat #6 and #7 for all 4 channels. Note: At 0% intensity the channel is turned OFF.
8.
Repeat #3 to #8 for all 8 Time Points.
9.
Press
Exit Button
to confirm and return to
Setup Mode
.
The settings are now saved. The settings will also be saved if the Controller Unit was left
idle for 30 seconds.
10.
To setup PROGRAM 2, perform #2 but select PROGRAM 2, then repeat
the above steps.
Controller Function – Setting up Moon Light
Moon-Light can be programmed into Program 1 or 2 by simply assign one or more of the LED
channels (preferably the blue LED channel) to operate at 1% brightness in the last Time Point.
