Maxon TE-250C, Руководство по обслуживанию

Страница: 14 / 48

1
1921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
14
CHECKING HYDRAULIC FLUID
CAUTION
Keep dirt, water and other contaminants from entering the hydraulic system.
Before opening the hydraulic fl uid reservoir fi ller cap, drain plug and hydrau-
lic lines, clean up contaminants that can get in the openings. Also, protect the
openings from accidental contamination.
+50 to +120 Degrees F - Grade ISO 32
Below + 70 Degrees F - Grade ISO 15 or MIL-H-5606
NOTE:
Use correct grade of hydraulic fl uid for your location.
See
TABLES 15-1 & 15-2
for recommended brands.
PERIODIC MAINTENANCE
1.
Unbolt and remove pump cover
(FIG. 14-1)
.
UNBOLTING/BOLTING PUMP COVER
FIG. 14-1
3.
If needed, add fl uid to the reservoir as fol-
lows. Pull out (no threads) fi ller cap
(FIG.
14-2)
. Fill the reservoir with hydraulic fl uid to
level shown in
FIG. 14-2
. Reinstall fi ller cap
(FIG. 14-2)
.
2.
Check the hydraulic fl uid level
in reservoir as follows. With
Liftgate stowed, or platform at
vehicle bed height, level should
be as shown in
FIG. 14-2
.
CAUTION
Pump cover must be correctly
secured to prevent it from be-
coming a hazard. To secure pump
cover, the long side of the holder
fl ats must butt against pump cov-
er as shown in the illustration.
4.
Bolt on the pump cover as shown
in
FIG. 14-1
. Torque the bolts (cap
screws) to
10-14 lb-in
.
CAP SCREW,
5/16”-18
(2 PLACES)
HOLDER FLAT
(2 PLACES)
FLAT WASHER,
5/16”
(2 PLACES)
NYLON NUT,
5/16”-18
(2 PLACES)
PUMP COVER
POWER UNIT
(REF)
POWER UNIT FLUID LEVEL
FIG. 14-2
FILLER
CAP
RESERVOIR
3”(PD)
1-1/2”(GD)