Maxon MXT-25, Руководство по обслуживанию

Страница: 45 / 61

1
1921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
45
CHECKING SOLENOID VALVE
FIG. 45-3
REMOVING “S1” SOLENOID VALVE
(GRAVITY DOWN POWER UNIT) FIG.
45-1
VALVE CARTRIDGE
1/8”
3.
Check the hydraulic cylinder. With the plat-
form at vehicle fl oor level, remove the hy-
draulic line from the
LOWER
port on the cyl-
inder
(FIG. 45-4)
. Hold the control switch in
the “
RAISE
” position for two seconds while
you watch for hydraulic fl uid at the
LOWER
port. A few drops of hydraulic fl uid escaping
the port is normal. However, if fl uid streams
out, piston seals are worn. Replace seals.
FIG. 45-4
LOWER PORT
RAISE PORT
REMOVING “S1” SOLENOID VALVE
(POWER DOWN POWER UNIT)
FIG. 45-2
NUT
COIL
VALVE
CARTRIDGE
2.
Make sure platform is on the ground. Remove
“S1”
lowering solenoid valve
(FIGS. 45-1 and
45-2)
. Push on the plunger in the valve by
inserting small screwdriver in the open end
(FIG. 45-3)
. If the plunger does not move with
a smooth, spring-loaded action (approximately
1/8”), replace the valve cartridge.
Reinstall
lowering solenoid valve. Torque valve
cartridge to 25-30 lb-ft and hex nut to 15-45
lb-in (TABLE 40-1)
.
NUT
COIL
VALVE
CARTRIDGE
NOTE:
In most cases, you can avoid having
to manually bleed hydraulic system by
correctly positioning Liftgate platform
before disconnecting any lifting cylin-
der high pressure hydraulic lines.
Keep dirt, water and other contaminants
from entering the hydraulic system. Before
opening the hydraulic fl uid reservoir fi ller
cap, drain plug and hydraulic lines, clean
up contaminants that can get in the open-
ings. Also, protect the openings from acci-
dental contamination during maintenance.
CAUTION