maxitrak 5 Inch Gauge Alice, Руководство по монтажу, Страница: 2 / 18

info@maxitrak.co.uk Copyright maxitrak 2010
Alice kit instructions
Please read through the instructions and familiarize your self with the parts before starting. Left
and right hand sides refer to the engine as seen from the drivers point of view. Copper pipe work
gets work hardened, if you are struggling to get it bent to shape you can anneal (soften) it by
getting it red hot and plunging in to water. Be careful not to melt any solder joints or fittings, you
can do this any number of times until the pipe is correct. Be careful on tight bends, squeeze the
pipe across its width in a vice if it begins to flatten.
1.
The chassis comes complete and may be run on air before commencing with the kit build. The
pipe work from the axle pump to the back of the engine should be removed for ease of build, be
sure not to lose the ball from the top of the pump. Put the washers and banjo bolt back in the pump
for safe keeping.
2.
Screw the blast pipe into the top of the valve block, center hole. This pipe will need to be
centralized under the chimney when the smoke box is in place. It is quite soft and can be bent to
shape as required.