MATTHIESEN Magic Finger Bagger, Руководство пользователя

Страница: 7 / 85

Set-up Instructions for Model VV510 Magic Finger Bagger
™
UNPACKING
Carefully remove equipment from crating.
™
CONVEYOR MOUNTING
Loosen the setscrews on the Conveyor Assembly support arms and flip the assembly over so
the motor is below the Conveyor belt and away from the Magic Finger Bagger.
™
CONVEYOR ELECTRICAL CONNECTION
Connect the L5-15 twist-lock plug on the Conveyor motor cord to one of the receptacles on the cords
from the Magic Finger Bagger pendant station. Keep excess cord away from standing water on floor.
™
WICKETED BAG INSTALLATION
Swing the wicket rod catch, item 20 on the Top Assembly drawing #B0000 backwards and down. Place
a correct sized wicket of bags (not supplied) on the wicket rods and slide them all the way forward to
the stop. Place the Gravity Weight, item 13 on the rods and allow it to slide down to the bags. Swing
the wicket rod catch, up and forward making sure that the wicket rods fall into the correct notches.
™
HAMER 125 BAG CLOSER MOUNTING
Loosen the setscrews on the Hamer 125 base (not supplied) and position it over the vertical tube on the
Hamer 125 mount on the Magic Finger Bagger. Retighten the setscrews. Loosen the screws, item 4 on
the Hamer 125 Mounting Assembly Drawing #B0056 on the topside of the Hamer 125 mount bracket
and move the Hamer 125 until its centerline is on the centerline of the Magic Finger Bagger. (Be certain
to hold the Hamer 125 upright when loosening the screws so that it does not rotate.) Retighten the
screws. Loosen the screws, item 5 on the underside of the Hamer 125 mount bracket and position
it
along the horizontal, square tube on the Magic Finger Bagger frame so that the tips of the feeder plates
on the Hamer 125 are approximately 6.00” from the first bag. Position Hamer with approximately 5˚ tilt
down this allows finger motion without interference. Retighten the screws. Connect the L5-15 twist-
lock plug on the Hamer Ring Bag Closer cord to the remaining receptacle on the Magic Finger Bagger
pendant station cords. Keep excess cord away from standing water on floor.
™
INFEED CONVEYOR ELECTRICAL CONNECTION
Connect the control circuit from feed conveyor motor (or mechanism that will deliver ice to the Magic
Finger Bagger Hopper) to the top proximity switch on the Magic Finger Bagger Hopper. When the
Hopper is full, it will open up the circuit and stop the flow of ice to the Hopper. When the ice in the
Hopper is beyond set proximity switch sensing range, it will close again, starting the flow of ice to the
Hopper.
7