MATTHIESEN Magic Finger Bagger, Руководство пользователя

Страница: 44 / 85

Section 1
General Information
2-2 Installation & Operation MN605
Doweling & Bolting
After proper alignment is verified, dowel pins should be inserted through the motor feet
into the foundation. This will maintain the correct motor position should motor removal be
required. (Baldor motors are designed for doweling.)
1. Drill dowel holes in diagonally opposite motor feet in the locations provided.
2. Drill corresponding holes in the foundation.
3. Ream all holes.
4. Install proper fitting dowels.
5. Mounting bolts must be carefully tightened to prevent changes in alignment.
Use a flat washer and lock washer under each nut or bolt head to hold the
motor feet secure. Flanged nuts or bolts may be used as an alternative to
washers.
Power Connection
Motor and control wiring, overload protection, disconnects, accessories and grounding
should conform to the National Electrical Code and local codes and practices. Ground
the motor by attaching a strap from an established ground point to the grounding bolt
provided inside the conduit box.
Conduit Box For ease of making connections, an oversize conduit box is provided. The box can be
rotated 360
°
in 90
°
increments.
Power Connect the motor leads as shown on the connection diagram located on the name plate
or inside the cover on the conduit box. Be sure the following guidelines are met:
1. DC power is within
±
5% of rated voltage (not to exceed 600VDC).
(See motor name plate for ratings).
OR
2. DC field power is within
±
1% of rated voltage.
Motor Connections Terminal connections should be made as specified. See the connection diagrams located
in Section 4 of this manual. Tables 2 − 1 and 2 − 2 show the NEMA standard lead markings
and the Accessory Markings.
Table 2 − 1 NEMA Standard Lead Markings
Lead Markings Motor
Armature A1, A2
Field (shunt) F1, F2, F3, F4, etc.
Field (series) S1, S2
Thermostat P1, P2, etc.
Space Heater H1, H2, H3, H4, etc.
Resistance Temperature Detector (RTD) R1, R2, R3, R4, etc.
Optional Brush Monitor System A1Probe, A2Probe
Table 2 − 2 Accessory Markings
DC Tachometers + —
XPY 1 2 G
XC Red (1) Black (2) G
NCS Pancake Red Black
AC Tachometers 45/90V Output
45V Red White
90V Red Black
Brake Coil Leads B1, B2, B3, etc.
Space Heater (Brake) H1, H2, H3, H4, etc.
Brake Interlock Switch BS1, BS2, BS3, etc.
44