MATTHIESEN Magic Finger Bagger, Руководство пользователя

Страница: 10 / 85

Timing and Adjusting the Model VV510 Magic Finger Bagger
™
ADJUSTING THE BAG RETAINER RODS ON THE BAG SHELF ASSEMBLY
The bag retainer rods can be adjusted for different width ice bags. To adjust the bag retainer rods, item
2 on Bag Shelf Assembly drawing #0062-B, loosen the setscrews in the collar and move them to the
desired position and retighten the setscrews. The bag retainer rods should be the same distance from the
Magic Finger Bagger and bag centerlines. When the bag is filled with ice, it starts to tear from the
wicket rods. When the Magic Finger take-off mechanism pulls the bag from the Bag Shelf Assembly
forward to the Conveyor Assembly it completes the separation. The bag retainer rods keep the wicketed
bags that are not being filled from being drawn forward and getting caught or pulled off too soon.
™
ADJUSTING THE AMOUNT OF AIR FLOWING TO OPEN THE ICE BAG
If the amount of air flowing to open the ice bag is too small, the ice bag will not open up all the way
which could result in a partially filled or an unfilled bag. It may also prevent the Magic Finger wand
from getting into the inside of the bag resulting in the bag not getting taken off the Bag Shelf. If it is too
large, it could blow the bag completely off of the wicket before the ice is even dropped. To adjust the
airflow, loosen the wingnut, item 10 on the Blower Assembly drawing #B0042 and rotate the shroud
damper, item 4 to cover either more of the opening for a smaller airflow, or cover less of the opening,
for a larger airflow. Retighten wingnut. The metering door, item 4 on the Ice / Air Chute Assembly
drawing #B0047 should close to about a ½” gap. To adjust the amount of gap, loosen the screws, item
11 and move the stop, item 5 to the desired location. This setting also affects the air-flow into the bag.
™
ADJUSTING THE CONVEYOR BELT HEIGHT
The Conveyor belt height and angle can be adjusted by loosening the setscrews, item 41 on the
Conveyor Assembly drawing #B0050 that connect the Conveyor to the support arms on the frame and
repositioning it. The top of the Conveyor belt end near the Magic Finger Bagger should be just below
the bottom of the Bag Shelf Assembly. The top of the other end of the Conveyor belt should be
positioned to allow a smooth transition (hand-off) to any ancillary take-off equipment being used.
10