MATSONIC MS7057C, Руководство пользователя

Страница: 49 / 78

43
Note: Before attempting to configure a hard disk drive, make sure
you have the configuration information supplied by the manufac-
turer of your hard drive. Incorrect settings can result in your
system not recognizing the installed hard disk.
Access Mode
This item defines some special ways that can be used to access IDE
hard disks such as LBA (Large Block Addressing). Leave this value at
Auto and the system will automatically decide the fastest way to access
the hard disk drive.
Press <Esc> to close the IDE device sub-menu and return to the Stan-
dard CMOS Features page.
Drive A and Drive B Default: 1.44M, 3.5 in., None
These items define the characteristics of any diskette drive attached to
the system. You can connect one or two diskette drives.
Floppy 3 Mode Support Default: Disabled
Floppy 3 mode refers to a 3.5-inch diskette with a capacity of 1.2 MB.
Floppy 3 mode is sometimes used in Japan.
Video Default: EGA/VGA
This item defines the video mode of the system. This mainboard has a
built-in VGA graphics system; you must leave this item at the default
value.
Halt On Default: All Errors
This item defines the operation of the system POST (Power On Self
Test) routine. You can use this item to select which types of errors in
the POST are sufficient to halt the system.
Base Memory, Extended Memory, and Total Memory
These items are automatically detected by the system at start up time.
These are display-only fields. You cannot make changes to these fields.