Matrix MyRide, Руководство по обслуживанию

Страница: 2 / 11

2
1.1 ASSeMBly iNSTRUCTiONS
MyRide ASSeMBly GUide
Assembly Instructions:
1. Remove all parts from the packaging and check to make sure that no parts are missing.
2. Install the heavy plate on the end of the MyRide frame and secure with a bolt / washer through any of the large mounting holes (Figure A).
3. Install one of the fins on the opposite side of the bolt / washer holding the heavy plate to the MyRide frame. Use 2 large bolts to secure the
fin to the MyRide frame. NOTE: The bend on the fin should be facing the center of the frame (Figure B).
4. Remove the bolt / washer holding the heavy plate in place that was installed in Step 2.
5. Install the remaining small fin to the MyRide frame. Use 2 large bolts to secure the fin to the MyRide frame.
NOTE:
Again make sure that
the bend is facing the center of the machine (Figure C).
6. Install the large fin with one bolt at the top of the fin and one at the bottom to hold the large fin to the MyRide frame (Figure D). Push up on
the large fin so that the holes in the fin align with the bottom of the slots, then install the remaining mounting bolts.
FiGURe A
FiGURe d FiGURe C
FiGURe B
ASSeMBliNG THe MyRide
Parts List:
Heavy Plate
Stabilizer Fin - Right
Stabilizer Fin - Left
Stabilizer Fin - Large Middle
Power Cord
Hardware Bag - Contains hardware, pads, and levelers
5mm Allen Wrench
8mm Allen Wrench