Matrix MyRide, Руководство по обслуживанию

Страница: 7 / 11

7
MyRide TROUBleSHOOTiNG
2.1 TROUBleSHOOTiNG - NO CONSOle diSPlAy
SyMPTOM:
1) The console turns on, but has the message "No Signal Input:.
2) The monitor does not turn on at all.
SOlUTiON:
1) Check the VGA cable (Figure A) that connects the monitor to the mini PC. Make sure that both ends are attached properly.
a. Disconnect the cable and check that all the pins on the VGA cable are straight.
b. If you see visible damage to the cable, replace it. You can use any generic VGA cable (like from a computer at the club) to test if this is
the issue as VGA cables are all pinned out the same.
c. If the cable was loose, you should see a signal right away.
d. Once the cable is replaced or disconnected, reboot power to the unit, then re-test.
2) Check the 2 LED's that are located on the top left side of the unit. The LED's should be green if the unit is in good working condition.
a. The top LED is red after start up before initial setup, and should turn green when the setup is complete.
- If the lower LED never turns on red or green, check the power jack coming to the monitor and the mini PC using a multi meter (Figure
B). Set the multi meter to DC voltage. You should be getting 12V (+ / - 5%) from the power supply to both the monitor and mini PC. The inside
is positive, the outside of the sheathing negative. NOTE: It is important to check the voltage at both locations as it is possible that one end will
work and the other will not. A good power supply will always send the same amount of power to both ends. If the voltage is higher or lower on
either end of the power supply, replace it after verifying fitness room power (make sure the outlet is outputting 120V).
- If the power supply voltage is correct to both ends, but the LEDs will not light correctly, replace the monitor.
b. There is a third LED near the mini PC at the bottom of the unit. This LED will turn red after start up before initial setup, then green, then
blue. The blue LED wil blink in normal conditions.
- If the blue LED never blinks (or does not light at all) and the system is not booting up normally, there is an issue with the PC hard drive,
and the mini PC should be replaced.
FiGURe A
FiGURe B