Matrix C5X-05, Руководство по обслуживанию, Страница: 45 / 48

85 84
10.6 PCTV bRACkET INSTAllATIoN INSTRUCTIoNS - CoNTINUEd
CHAPTER 10: ClIMb MIll SPECIfICATIoNS ANd ASSEMbly gUIdE
7) Run the white end from the Y cable through the headphone jack hole in the console plastic, and plug it into the headphone jack sent with the
TV bracket set (Figure G).
8) Mount the headphone jack into the console plastic using the 2 screws removed in Step 3 (Figure H).
9) Plug the of the TV controller extension wire into the PCTV port on the CSafe board in the console (Figure I). Make sure that the switch
(SW1) is in the top position. Route the controller extension wire so that the opposite end is coming out the bottom of the console. Then
re-install the 6 screws removed in Step 3.
10) Remove the 3 screws holding the cap on the Climb Mill frame and remove it (Figure J).
11) Install the spring pin sent with the bracket kit into the slot in the bracket (Figure K).
12) Mount the rabbit ears to the bracket using the long screw, washers, and Nylok nut sent with the bracket kit (Figure L). NOTE: Make sure
that the slot in the rabbit ear lines up with the spring pin installed in Step 11 to limit the angle of the TV.
fIgURE g fIgURE H
fIgURE I fIgURE J
fIgURE k fIgURE l
foR
PCTV
Sw1 IN ToP
PoSITIoN
foR PCTV
10.6 PCTV bRACkET INSTAllATIoN INSTRUCTIoNS - CoNTINUEd
CHAPTER 10: ClIMb MIll SPECIfICATIoNS ANd ASSEMbly gUIdE
13) Route the TV controller wire, net wire, power wire, and coax cable through the bracket (Figure M). There should now be a black adaptor
(power wire), white RJ45 connector labeled TO TV (controller wire), yellow RJ45 connector (net wire) and coax cable sticking out the top of the
bracket.
14) Route the wiring coming out the bottom of the bracket through the Climb Mill frame. The controller wire, net wire, power wire, and coax
cable should now be coming out of the console mast along with the normal console and heart rate cables (Figure N).
15) Mount the TV bracket to the Climb Mill frame using the 3 screws removed in Step 10 (Figure O).
16) Mount the TV to the bracket using 4 screws (Figure P).
17) Plug the coax cable into the TV (Figure q).
18) Plug the power wire into the TV (Figure R).
fIgURE M fIgURE N
fIgURE o fIgURE P
fIgURE Q fIgURE R