79
78
10.5 MyE TV bRACkET INSTAllATIoN INSTRUCTIoNS - CoNTINUEd
CHAPTER 10: ClIMb MIll SPECIfICATIoNS ANd ASSEMbly gUIdE
7) Run the white end from the Y cable through the headphone jack hole in the console plastic, and plug it into the headphone jack sent with the
TV bracket set (Figure G).
8) Mount the headphone jack into the console plastic using the 2 screws removed in Step 3 (Figure H).
9) Remove the existing heart rate overlay from the lower portion of the console (Figure I).
10) Clean the console area with alcohol to remove any left over adhesive from the console plastic (Figure J).
11) Peel off the protective film from the back of the entertainment keypad / overlay (Figure K).
12) Push the ribbon cable end through the hole in the console plastic (Figure L).
fIgURE g
fIgURE H
fIgURE I
fIgURE J
fIgURE k
fIgURE l
10.5 MyE TV bRACkET INSTAllATIoN INSTRUCTIoNS - CoNTINUEd
13) Press the entertainment keypad / overlay into the cutout in the console plastic (Figure M).
14) Plug the ribbon cable into the open pins on the UCB (Figure N). Make sure that the pins and ribbon cable are correctly aligned with no pins
open on the UCB.
15) Plug the of the TV controller extension wire into the TV port on the CSafe board in the console (Figure O). Route the controller extension
wire so that the opposite end is coming out the bottom of the console. Then re-install the 6 screws removed in Step 3.
16) Remove the 3 screws holding the cap on the Climb Mill frame and remove it (Figure P).
17) Install the spring pin sent with the bracket kit into the slot in the bracket (Figure q).
18) Mount the rabbit ears to the bracket using the long screw, washers, and Nylok nut sent with the bracket kit (Figure R).
NOTE:
Make sure
that the slot in the rabbit ear lines up with the spring pin installed in Step 17 to limit the angle of the TV.
fIgURE M
fIgURE N
fIgURE o
fIgURE P
fIgURE Q
fIgURE R
CHAPTER 10: ClIMb MIll SPECIfICATIoNS ANd ASSEMbly gUIdE