45
44
CHAPTER 9: PART REPlACEMENT gUIdE
9.3 CoNSolE kEyPAd / oVERlAy REPlACEMENT - CoNTINUEd
fIgURE E
fIgURE f
fIgURE g
7) Peel part of the protective film from the back of the overlay (Figure E).
8) Push the overlay ribbon cable through the hole in the console and plug it in (Figure F).
9) Match the overlay to the cutout on the console (Figure G).
10) Press down on the corners of the overlay to keep it in place, then remove the protective film (Figure H & I).
11) Once the overlay is in the correct position, press down on the overlay with a cloth to adhere it to the console plastic (Figure J).
12) Use the same procedure to replace any additional faulty overlays.
NOTE:
Overlays can not be reused.
13) Test the Climb Mill for function as outlined in Section 9.21.
fIgURE H
fIgURE I
fIgURE J
9.4 fRoNT SHRoUd REPlACEMENT
1) Turn off power and disconnect the cord from the machine.
2) Remove all of the cables from the front cover (Figure A).
3) Remove the 2 screws from the front cover and remove it (Figure B).
4) Remove both side covers as outlined in Section 9.1.
5) Remove the console as outlined in Section 9.2.
6) Remove the 3 screws on each side that connect the front shroud to the frame (Figure C).
7) Remove the 5 screws that hold the upper handlebar set to the console mast (Figure D).
fIgURE d
fIgURE b
fIgURE C
fIgURE A
CHAPTER 9: PART REPlACEMENT gUIdE