Matco Tools FixAdvisor MD70, Руководство по эксплуатации

Страница: 75 / 104

Additional Tests
EVAP LEAK TEST
MD70 73
1. From the "Special Test Menu ", use the UP
and DOWN buttons, as necessary,
to highlight Non-Continuous Test , then
press the ENTER button.
2. A “One moment please. . .” message
displays while the request is sent to the
vehicle’s on-board computer.
„ The “Select Test” screen displays. The
screen shows all tests applicable to the
vehicle under test. Refer to the
vehicle’s service repair manual for
information related to non-continuous
tests.
If non-continuous tests are not
supported by the vehicle under test, an
advisory message shows on the
FixAdvisor’s display. Press the
M
button to return to the Special Test
Menu.
3. Use the UP and DOWN buttons,
as necessary, to highlight the desired test,
then press the
ENTER button.
4. When test results have been retrieved,
data for the selected test will show on the
FixAdvisor’s display. The display shows
the following information:
„ Test ID number
„ Module ID number
„ Component ID number
„
Min or Max test limit
Only one test limit, either Min or Max , is shown for any
given test.
„ Test Value and Status
Status is calculated by the FixAdvisor by comparing the Test
Value against the displayed test limit (either Min or Max ).
Status is shown as either Low , High or OK .
5. When you have finished viewing the retrieved test data, press the M
button to return to the “Select Test” screen.
EVAP LEAK TEST
The EVAP Leak Test function lets you initiate a leak test for the
vehicle's EVAP system.