INSTALLATION
20
October 2010 / Digital DC 10x10A / EN
6.4
INSTALLATION STEP BY STEP
Disconnect the electrical power:
•
Switch off all connected components.
•
Disconnect the battery DC poles, the positive
pole first.
•
Check with a suitable voltmeter whether the
entire DC installation is voltage free.
•
Mount the DC output wiring. Mount the negative
wires first and then the positive wires.
•
Cut the end cap if necessary, see figure 19.
6.5 HIGH
POWERING
The Digital DC 10x10A is a high powering
MasterBus device. This type of device gets priority
from low powering MasterBus devices when
MasterBus power is needed.
1. DC In, positive line
2. DC In, negative line
3. Hardware fuses with two
positions each
4. DC Output 1-5
Positive at the left,
Negative at the right.
For connecting the
cables see figure 17.
5. MasterBus cables
6. DC Output 6-10
7. End cap, section 1 cut.
Figure 20: Installation of the Digital DC 10x10A
Another way to organize
the cables is shown in
figure 22. This way is
applicable only when no
MasterConnect devices
are connected to the
Digital DC 10x10A directly
and the DC cables are not
too thick. The end cap
has sections 1 and 2 cut
out.
Figure 22: Organizing cables sideways
1
2
Figure 21: Use of the spring cage terminal block
Connecting the cables
1 Push screwdriver firmly into upper slot.
2 Place cable into opening and pull back
screwdriver.
