Integrity Bath
–
Model MB-80
Maintenance Manual
07-06-15
Page 5 of 16
2071 14
th
Ave – Columbus, NE 68601
800-798-5867 FAX: 402-563-9102
www.mastercarebath.com
DOOR IN/OUT ADJUSTMENT
Properly adjusted the door will stop just short of the
inside
tub rails.
To adjust, locate the CAP HEAD SCREW that acts
as a stop for the door. See item #
6
coupled with item
#
4
on
drawing
#804305.
Loosen the LOCK NUT at the base of the
screw. Adjust in and out as needed. Lock into place with
LOCK NUT. See drawing to the right.
DOOR SLIDE END CAP
Inspect the SLIDE END CAP item#
3
in drawing#
803966
. It
should not be worn through on the side that contacts the
outer surface of the door. To replace:
1.
Remove old end cap.
2.
Clean any residual adhesive.
3.
Smear a small amount of clear silicone on inside of
new cap.
4.
Push on.
DOOR GAS SPRING REPLACEMENT
Release door by pulling out on door catch bracket knob.
The bracket on the door mount assembly (item #
5
drawing
804500
) will be against the door lock mount bracket.
(item#
10
drawing
804500)
. Clamp the two brackets
together using a cushion between the clamp terminal.
Remove the hex socket pipe plug (item #
1
drawing
804500)
. Remove the old gas spring and replace with new
spring, part #
802235
.
DRAWINGS 804500
LOCK
NUT
CAP HEAD
SCREW
SLIDE END
CAP
