MAX STEREO SYSTEM / SPA THEATER SYSTEM (STS)
Available on select Master Spa and Down East Models
Note: Speakers should be in the down position before covering your spa. Failure to do so will result in
damage not covered under the warranty.
Note: UV rays may interfere with the operation of the remote.
57
DO NOT DIVE.
Note: Do not place wet CD’s into the stereo at anytime.
Note: Do not place wet DVD’s into the DVD player at anytime.
Note: AM channels will be very limited in reception and in most cases be unavailable.
CAUTION –
Risk of Electric Shock. Do not leave compartment door open.
CAUTION –
Risk of Electric Shock. Replace components only with identical components; and
Do not operate the Audio / Video controls while inside the spa.
WARNING –
Prevent Electrocution. Do not connect any auxiliary components (for example
cable, additional speakers, headphones, additional Audio / Video components, etc.) to the system.
NOTE: These units are not provided with an outdoor antennae; when provided, it should be installed
in accordance with article 810 of the National Electrical Code, ANSI / NFPA 70.
NOTE: Do not service this product yourself as opening or removing covers may expose you to dangerous
voltage or other risk of injury. Refer all servicing to qualified service personnel.
NOTE: When the power supply connections or or power supply cord(s) are damaged; if water is
entering the Audio / Video compartment or any electrical equipment area; if the protective
shields or barriers are showing signs of deterioration; or if there are signs of other potential
damage to the unit, turn off the unit and refer servicing to a qualified service personnel.
NOTE: This unit should be subjected to periodic routine maintenance (for example, once every 3 months)
to make sure that the unit is operating correctly.
INSTALLATION INSTRUCTIONS
7.
It may be necessary to bleed air from the motor(s) on your spa if, after start up, your spa pumps
do not operate.
Due to the nature of water flow and hydro-therapy pumps, please be advised that air locking of
pumps may occur. Master Spas has taken measures to reduce the possibility of this, but it still may
occur, especially after refilling a spa. This is not a service covered under warranty.
To relieve an airlock situation, loosen the union (see picture) on the discharge of the pump (the end
of the pump that water is being pushed through). Water should leak out. Tighten the union and
test the pump for proper jet flow. If needed repeat process.
20
DO NOT DIVE.
Airlock
Pump Union
Slice Valve
8.
Adjust water chemistry according to the instructions provided in the “Spa Water
Maintenance Section”.
9.
Your spa water will heat approximately 5° - 8° per hour, for all 240V spas. This varies depending
on the size of the spa. Step into the soothing waters of your new Master Spa!
Relax and enjoy.
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
