SPA TROUBLE SHOOTING GUIDE
NOTHING ON THE SPA OPERATES-
1.
Check the control panel display for any messages. If there is a message, refer to the diagnostic section
on that model spa. There you will find the meaning of the message and what action is to be taken.
2.
If there is no message on your control panel, check and reset the GFCI and house breaker.
69
DO NOT DIVE.
*The GFCI should be located in a weather proof box close to the spa,
but no closer than 5 ft.
If the spa does not respond, contact your local service company.
PUMP(S) DO NOT OPERATE -
1.
Press the “Jets” button on your control panel.
If you hear the pumps trying to operate:
A. Check that all the slice valves are open. See photo on page 14.
B. Pump may need to be primed. See page 20.
C. Check that the air controls are open. See photo on page 12.
If you do not hear anything from the pump, contact your local service company.
POOR JET PERFORMANCE
1.
Make sure pump is operating
2.
Check that the water level is adequate (up to minimum safe water level side)
3.
Make sure the jets are open and the air controls are open. See page 12.
4.
Check for dirty filters. Clean if necessary.
SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
(CONT.)
15. A green coloured terminal or a terminal marked G, GR, Ground, Grounding or the symbol shown
in Figure 14.1 of UL1563 is located inside the supply terminal box or compartment. To reduce the
risk of electric shock, this terminal must be connected to the grounding means provided in the
electric supply service panel with a continuous copper wire equivalent in size to the circuit
conductors supplying this equipment.
16. At least two lugs marked “Bonding Lugs” are provided on the external surface or on the inside
of the supply terminal box or compartment. To reduce the risk of electric shock, connect the local
common bonding grid in the area of the spa to these terminals with an insulated or bare copper
conductor not smaller than No. 6 AWG.
17. All field-installed metal components such as rails, ladders, drains, or other similar hardware within
3m of the spa shall be bonded to the equipment grounding bus with copper conductors not smaller
than No. 6 AWG.
SAVE THESE INSTRUCTIONS.
8
DO NOT DIVE.
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
