11
Operating Instructions
Figure 1
1 lb
453 g
7.75 in
. / 19,7 cm
3.875 in. / 9,8 cm
2.9 in. / 7,4 cm
1 lb
453 g
10.6 in.
/ 26,9 cm
Figure 3a Figure 3b
Figure 4
X
Figure 5
X
X
Figure 6
This grill is designed to operate with a one pound 7.75” or 10.6” high disposable / 16.4
oz. or 14.1 oz. propane gas tank (DOT 39 Cylinder). (Figure 1)DO NOT ATTEMPT TO
REFILL ANY ONE POUND (16.4 oz. or 14.1 oz.) PROPANE GAS TANKS!
Connect LP Gas Tank
Only cylinders marked “propane” may be used.Note: Some 1-lb cylinders may form frost
when near empty.
1. Make sure the regulator/control knob is in the “LOCK/OFF” position. (Figure 2)
2. Lubricate the threads of the regulator/control knob with petroleum jelly. Line up threads
on LP gas tank with regulator/control knob.
3. Insert and rotate LP gas tank clockwise until they fit snugly together. HAND TIGHTEN
ONLY. Be careful not to cross threads when screwing in canister. (Figure 3a)
4. Test for leaks, see “Checking for Leaks” section.
Disconnect LP Gas Tank
1. Turn the regulator/control knob to the “LOCK/OFF” position. (Figure 2)
2. Rotate LP gas tank counterclockwise until it is loose. (Figure 3b)
3. Store the LP gas tank in a proper location.
Burner Connection
Make sure the regulator/control knob is securely fastened to the burner. (Figure 4)
Note: The brass nut should be 1/4 to 1/2 turn past tight. The regulator will rotate 360º
even when the brass nut is tightened.If your unit was assembled for you, visually check
the connection between the burner and control valve.
If you have questions contact 1-866-814-0585 for assistance.
WARNING: Failure to inspect this connection or follow these instructions
could cause a fire or an explosion which can cause death, serious bodily
injury or damage to property.
Checking for Leaks
1. Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three
parts water.
2. Make sure regulator/control knob is “LOCK/OFF”. (Figure 2)
3. Spoon several drops of solution, or use squirt bottle, at all “X” locations. (Figures 4 & 5)
4. Inspect the solution at the connections, looking for bubbles.
a. If NO bubbles appear after one minute, the connections are secure. Wipe away solution
and proceed.
b. If bubbles appear, you have a leak.
1. Remove the LP gas tank and reconnect, making sure the connection is secure.
2. Retest with solution. If you continue to see bubbles after several attempts, disconnect
LP gas tank and contact 1-866-814-0585 for assistance.
First Use
1. Make sure all labels, packaging and protective films have been removed from the grill.
2. Remove manufacturing oils before cooking on this grill for the first time by operating the
grill for at least 15 minutes on “HIGH” with the lid closed. This will “heat clean” the
internal parts and dissipate odors.
Figure 2
LOCK OFF
OFF
LOW
MED
HIGH
PUSH
TO
TURN ON
Match
