Marzhauser Sensotech PROFILER ST, Руководство по эксплуатации

Страница: 169 / 196

169
Troubleshooting PROFILER ST
EN
Fault Possible causes Remedy
PROFILER ST doesn’t
turn on no power supply Check whether the external power supply is properly connected to the
24V/DC port on the PROFILER ST and the socket.
Position display shows
NO SENSOR for an axis
wrong encoder type selected Check the settings for the encoder type of the affected measuring system.
»
Chapter 6.7.6 Encoder, page 148
incorrect cabling 1 Disconnect the power supply of the PROFILER ST from the mains.
2 Check whether the affected measuring system is properly connected to the
PROFILER ST over the correct port.
3 Connect the power supply of the PROFILER ST to the mains.
4 Check the position display of the affected axis.
measuring channel is not need-
ed Disable the position displays of unused measuring channels.
»
Chapter 6.7.6 Encoder, page 148
Position values un-
usual or demonstrably
incorrect incorrect information about the
encoder type or signal period/
counting step Check the settings for the encoder type and the signal period/counting step of
the affected measuring system.
»
Chapter 6.7.6 Encoder, page 148
faulty position correction values 1 Check the position correction values of the affected measuring system.
2 Correct faulty position correction values or, if necessary, delete all position
correction values and configure the position correction once more.
»
Chapter 6.5.2 Configuring the Position Correction, page 130
connection of an incompatible
measuring system Check the specifications of the affected measuring system.
»
Chapter 4.1 Intended Use, page 109
Position correction
does not work machine zero not set/
approached (
status display pos-
ition correction of the respective
axis flashes red)
•
If Set machine zero with button function is selected: After switching on the
PROFILER ST, manually set the machine zero with , or .
•
If Set machine zero with reference mark function is selected: Approach the
ref erence marks of all axes after switching on the PROFILER ST.
»
Chapter 6.7.3 Origin, page 140
position correction for the
affected axis is disabled Enable the position correction for the affected axis.
»
Chapter 6.7.6 Encoder, page 148