NOTE:
1. Never mix gasoline and oil directly in the Hedge Trimmer fuel tank.
CAUTION!
1. Do not use National Marine Manu1acturer's Association {NMMA) or BIA certified oils. This type
or 2-cycle engine oil does not have the proper additives for air-cooled, 2-cycle engines and can
cause engine damages.
2. Do not use automotive motor oil. This type of oil does not have the proper addttives for air
cooled, 2-cycled engines and can cause engine damage.
ADJUSTING THE CUTTING BLADES
A
CAUTION-DO NOT TOUCH THE SHARPENED EDGES OF THE CUTTING
BLADES. THE CUTTING BLADES ARE EXTREMELY SHARP AND DANGER
OUS AT ALL TIMES. ALWAYS WEAR GLOVES TO HELP PROTECT YOUR
HANDS AND FINGERS FROM INJURY.
Before operating the Hedge Trimmer It is necessary to check the adjustment of the cutting blades.
Blades that are too loose may vibrate, and will not provide a clean, smooth cut.
A_
CAUTION-BLADES THAT ARE TOO TIGHT CAN CAUSE OVERLOADING
.. WHICH MAY DAMAGE THE EQUIPMENT.
To adjust the cutting blades, refer to the illustrations and locate the screws.
Loosen the nuts.
Gently turn the screws in until snug, then turn the
screws back out one-fourth to a half. While holding
the screws in place, tighten the nuts. Liberally
coat the cutting blades with light oil. Start the
engine and operate the Hedge Trimmer at full
speed for at least one minute. Stop the engine,
and when the blades are motionless, touch the
blades with your hand.
NUT
mw�
y>
ornoeMs
> I
�
>
LOWER BLADE
· WASHER
The blades should be warm, but if they are too hot to
touch, loosen the screws 1/8 tum.
ROTATIONAL REAR HANDLE (HT2320D-R)
Rear handle is adjustable to five different positions by
pulling the lock lever and turn the rear handle. Pull the lock
lever directly in line with the handle (following the arrow in
fig), then turn the rear handle.It is extremely important that
the handle is completely located and correctly locked in
the selected position.
Vi
SCREW
�a½
SCREWS
LOCK LEVER
