
86
797-74E-I
Omni MPI
EMERGENCY SERVICE
10-3
3)
Make jump lead connections as follows:
a) Connect one end of the first jump
lead to the positive (+) terminal of
the flat battery.
b) Connect the other end to the positive
(+) terminal of the booster battery.
c) Connect one end of the second
jump lead to the negative (-)
terminal of the booster battery.
d) Make the final connection to an
unpainted, heavy metal part of the
engine of the vehicle with the flat
battery.
w
WARNING
Never connect the jump lead directly
to the negative (-) terminal of the
discharged battery, or an explosion
may occur.
4)
If the booster battery you are using is
fitted to another vehicle, start the
engine of the vehicle with the booster
battery. Run the engine at moderate
speed.
5)
Start the engine of the vehicle with the
flat battery.
6)
Remove the jump leads in the exact
reverse order in which you connected
them.
CAUTION
TOWING
To help avoid damage to your vehicle
during towing, proper equipment and
towing procedures must be used.
If the steering and drivetrain are in good
condition, your vehicle should be towed
from the rear with the rear wheels lifted
and the front wheels on the ground. Your
vehicle may be towed from the front with
the front wheels lifted and dolly under rear
wheels. Before towing, make sure the
steering is unlocked and the transmission
is in neutral.
If you need to have your vehicle towed,
contact a professional service.
EMERGENCY REMEDIES
If the Starter Does Not Operate:
1) Try turning the ignition switch to the
“START” position with the headlights
turned on to determine the battery
condition. If the headlights go excessively
dim or go off, it usually means that either
the battery is flat or the battery terminal
contact is poor. Recharge the battery or
correct battery terminal contact as
necessary.
2) If the headlights remain bright, check the
fuses. If the reason for failure of the
starter is not obvious, there may be a
major electrical problem. Have the vehicle
inspected by your authorized MARUTI
SUZUKI dealer.
If the Engine is Flooded
If the engine is flooded with petrol, it may be
hard to start. If this happens, press the
accelerator pedal all the way to the floor and
hold it there while cranking the engine. (Do not
operate the starter motor for more than 5
seconds). Release the accelarator as soon as
the engine has started.
Содержание Omni E 8 STR BS-IV
