MARUTI SUZUKI Baleno RS, Руководство пользователя, Страница: 151 / 323

3-16
OPERATING YOUR VEHICLE
68PH5-74E
68PH30002
1) Make sure the parking brake is set fully.
2) Manual transmission – Shift to “N”
(Neutral) and fully depress the clutch
pedal. Hold the clutch and brake pedals
fully depressed.
CVT – If the gearshift lever is not in “P”
(Park) position, shift it to “P”. Hold the
brake pedal fully depressed.
3) The “PUSH START SWITCH” message
will appear on the information display in
the instrument cluster. Press the engine
switch (1).
4) Within about 10 seconds of blinking of
the master warning indicator light in the
instrument cluster, touch the engine
switch with the “LOCK” button end of
the remote controller (2) for about 2
seconds.Then you should be able to
select ignition modes & start the
engine.
NOTE:
• If you still cannot start the engine after
several attempts using the above
method, there may be a problem else-
where, such as a low battery. Contact
your Maruti Suzuki authorised workshop
for inspection.
• The immobilizer/keyless push start sys-
tem warning light will come on for about
5 seconds while the master warning indi-
cator light is blinking. In addition, the
information display will show a certain
message during this time. Refer to
“Information Display” in the “BEFORE
DRIVING” section for details.
• You may customize the system to cause
the interior buzzer to sound once for the
“remote controller out of sensing range”
warning. Please contact Maruti Suzuki
authorised workshop for the customiza-
tion.
• If the battery of the remote controller is
about to be completely discharged, a
message warning will appear on the
information display when the ignition
mode is changed to “ON” by pressing
the engine switch. For details on replac-
ing the battery, refer to the “Keyless
Push Start System Remote Controller” in
the “BEFORE DRIVING” section.
Returning the ignition mode to
“LOCK” (OFF)
CVT – To ensure safety, the ignition mode
can be returned to “LOCK” (OFF) by press-
ing the engine switch only when the gear-
shift lever is placed in the “P” position
without pressing the knob button.
NOTE:
Certain problems like a fault in engine sys-
tem may prevent the engine switch from
going back to the “LOCK” (OFF) mode. If
this happens, have the vehicle inspected
by Maruti Suzuki authorised workshop
after doing the following:
• Lock the doors using the key to prevent
theft. (The request switches and the key-
less push start system remote controller
cannot be used to lock them.)
• Disconnect the negative cable from the
lead-acid battery to prevent discharge.
“LOCK” (OFF) mode reminder buzzer
If the driver’s door is opened without
returning the ignition mode to “LOCK”
(OFF) by pressing the engine switch, a
buzzer sounds to warn you of this state.
• If you open the driver’s door after press-
ing the engine switch to change the igni-
tion mode to “ACC”, the interior buzzer
beeps intermittently.
• The buzzer will stop sounding if you then
push the engine switch twice, thus bring-
ing it back the ignition mode to “LOCK”
(OFF).
(1)
(2)
EXAMPLE