Marus TL 500, Руководство пользователя

Страница: 15 / 36

13
Adjusting the Light-head’s Vertical Rotation
1. Remove the yoke end-caps on both
sides of the yoke assembly by grip -
ping the lip of the end-cap cover and
pulling straight out.
2. Using the special tool provided, tight-
en or loosen the adjustment screws
on both sides of the yoke as needed
to achieve the desired friction.
3. Make the adjustments in small in-
crements, checking the result after
each. Match the adjustment on each
side to achieve even friction.
To correct a stiff or loose movement:
Adjusting the Light-head’s Horizontal Rotation
1. Remove the plug located at the rear of the pivot housing.
2. Insert a 3/32” hex wrench into the tension screw. Tighten
or loosen the tension screw in small increments, test-
ing the movement as you go, until the desired tension is
achieved.
3. Reinstall the plug.
Plug
Pivot
adjustment
screw
Yoke end cap
Avoid pinching this wire
Caution! While making adjustments, avoid
pinching the wire that runs through the yoke
assembly. A short circuit can cause serious
damage to the light.