Marus TL 500, Руководство пользователя, Страница: 12 / 36

10
The 115VAC/230VAC service line for
the track light should be evaluated
and installed by a licensed electri -
cian in accordance with local electri-
cal codes.
We recommend that a wall switch be
installed in the power supply to fa -
cilitate servicing and protect the light
transformer in the event of power
surges while the light is not in use
(i.e., electrical storms).
Electrical Requirements
*We recommend installation to be
performed by a qualified technician.
1. After the required support
structure is in place, remove
the track from its shipping
container. Remove the plastic
end cap from each end of the
track, remove the transformer
cover and remove the side trim
panels. The side trim panels
are removed by pulling straight
outward after the end caps are
removed. (See figure below).
2. Use 5/16” lag bolts (not in -
cluded) of a length that will
penetrate at least 3/4” into
solid wood to attach the pallet
to the ceiling or support struc-
ture. Holes can be drilled and
countersunk in other locations
along the edges of the pallet, if
required, to align with existing
ceiling joists or support struc-
ture. Be sure that the heads
of the lag bolts do extend
past the surface of the pallet.
The side trim extrusions will
not fit unless the heads are
flush.
CAUTION: The ceiling or support structure and hard-
ware used must be capable of supporting 200 lbs. dead
weight.
Installation Instructions