Martin SynchroZap QX250, Руководство пользователя

Страница: 8 / 24

8 S y n c h ro Z a p QX 2 5 0
1. Verify that the structure can support at least 10 times the weight of all installed
fixtures, clamps, cables, auxiliary equipment, etc.
2. If hanging the fixture with a rigging clamp, verify that the clamp is undam-
aged and is designed for the fixture’s weight. Bolt the clamp securely to
the bracket with a grade 8.8 (minimum) M12 bolt and lock nut, or as rec-
ommended by the clamp manufacturer, through the clamp hole in the
mounting bracket.
3. If permanently installing the fixture, verify that the hardware (not
included) and mounting surface can bear at least 10 times the fixture’s
weight. The four 6 mm holes and/or the 13 mm clamp hole in the mount-
ing bracket may be used for attachment.
4. Working from a stable platform, clamp or fasten the fixture to the struc-
ture.
5.
Install a safety cable that can hold at least 10 times the weight of the fix-
ture through/over the support and mounting bracket.
6. Loosen the tilt locks, tilt the fixture to the desired angle, and retighten.
7.
Verify that the fixture is at least 0.3 meters (12 in.) from the surface to be
illuminated and at least 0.1 meters (4 in.) from any combustible materials.
Verify that the clearance around the air vents is at least 0.1 meters (4 in.).
C o n n e c t i n g t h e s e r i a l d a t a l i n k
The SynchroZap must be connected by a serial data link if it is to be operated by a control-
ler or in stand-alone master/slave mode. The pin-out of the 3-pin data input and output
sockets is compatible with the DMX-512 standard, i.e., pin 1 to shield, pin 2 to cold (-)
and pin 3 to hot (+). As some devices have 5-pin connectors or 3-pin connectors with
reversed polarity on pins 2 and 3, the following adaptor cables may be required.
Phase-Reversing
Adaptor
Male Female
1
2
3 1
2
3
3-pin to 3-pin
P/N 11820006
Adaptor
Male Female
1
2
3
4
5 1
2
3
5-pin to 3-pin
P/N 11820005
Adaptor
Male Female
1
2
3 1
2
3
4
5
3-pin to 5-pin
P/N 11820004