1 1
O p e r a t i o n
s e c t i o n 3
O P E R A T I O N
S t a n d - a l o n e o p e r a t i o n
The SynchroZap QX250 may be operated without a controller in a stand-alone mode in
which it performs a random sequence triggered by the beat of the music. Two or more Syn-
chroZap QX250s may be connected for synchronized stand-alone “master/slave” operation.
S i n g l e S y n c h r o Z a p
1.
With the fixture off, set DIP-switch pins 1,2, and
10 to ON and set the others to OFF.
2.
Apply power to the SynchroZap QX250.
Adjust the volume of the music until the fix-
ture responds.
M u l t i p l e S y n c h r o Z a p s
1.
Link the fixtures together as described under
“Connecting the serial data link” on page 8.
2.
Select one SynchroZap to be the “master”
by setting its DIP-switch pins 1, 2, and 10 to
ON as shown above. Any SynchroZap - but
no more than 1 - may be the master regard-
less of its position on the link.
3.
Set all other SynchroZaps to be “slaves” by setting DIP-switch pin 1 to
ON and setting all other pins to OFF.
4.
Apply power to the fixtures. Adjust the volume of the music until the fix-
tures respond.
C o n t r o l l e r o p e r a t i o n
The SynchroZap QX250 may be operated with any DMX-512 controller. It is ideally suited
for use with the Martin 2518 DMX Controller.
G e t t i n g s t a r t e d
1.
Set up the SynchroZap QX250 as described in section 2.
2.
Switch on and configure the controller.
10
2
3
4 5
1
8
6 7
9
On
Stand-alone setting for
single or master unit
10
2
3
4 5
1
8
6 7
9
On
Stand-alone setting for
slave units
Содержание SynchroZap QX250
Страница 1: ...SynchroZap QX250 User Manual P N 35000025 ...
