Setup
5
S
ETUP
L A M P I N S T A L L A T I O N
The Juggler is shipped with a Philips 24V/250W ELC 500 hour halogen lamp
installed. When replacing the lamp, use only one of the compatible lamps listed
on page 10.
Installing any other lamp may damage the fixture!
Allow the lamp to cool for at least 5 minutes before moving the fixture. To avoid
possible damage, remove the lamp when shipping the fixture.
Warning!
Disconnect the fixture from AC power and allow the fixture to
cool for 5 minutes before installing a new lamp.
To i nst al l a l amp i n t he J uggl e r
1 Disconnect the fixture from AC power. If replacing a lamp, allow it to cool for
5 minutes before removing the lamp access cover. The lamp cools faster with
the cover in place.
2 Remove both screws from the lamp access cover and lift the cover off.
3 Grasp the old lamp by the reflector and pull it out of the holder. Then pull the
socket off the lamp. Do not pull the wires.
4 Push the socket fully onto the pins of the new lamp.
5 Gently push the lamp into the holder until it snaps into place.
6 Replace the lamp access cover and screws.
A C P O W E R C O N N E C T I O N
The fixture’s mains lead may require a grounding-type cord cap that fits your
power distribution cable or outlet. Consult a qualified electrician if you have
any doubts about proper installation.
