Setup
7
4 If permanently installing the fixture, verify that
the hardware (not included) and m ounting
surface can bear at least 10 times the fixture’s
weight. The four 6 mm holes and the clamp hole
i n th e m o u n t i n g b r a c k e t m a y b e u s e d f o r
attachment.
5 Working from a stable platform, clamp or fasten
the fixture to the structure.
6 Install a safety cable that can hold at least 10
times the weight of the fixture through/over the support and mounting
bracket as shown.
7 Loosen the swivel locks, tilt the fixture to the desired angle, and retighten.
8 Verify that the fixture is at least 0.3 meters (12 in.) from the surface to be
illuminated and at least 0.1 meters (4 in.) from any combustible materials.
Verify that the clearance around the air vent and lamp access plate is at least
0.1 meters (4 in.).
To use the br ack et as a fl oor s ta nd
The Juggler may be placed on the floor
by standing it squarely on the mirror end
or with the support of the mounting
bracket.
Never lay the fixture flat on its
back!
1 (Optional) Install the mounting bracket as described above.
2 Set the fixture flat on its mirror end or in one of the positions shown below.
Adjust the mounting bracket and tighten both swivel locks.
3 Verify (1) that the fixture is stable, (2) that the fixture is at least 0.3 meters (12
in.) from the surface to be illuminated and at least 0.1 meters (4 in.) from any
combustible materials, and (3) that the clearance around the air vent and
lamp access plate is at least 0.1 meters (4 in.).
Rigging clamp not shown!
