Martin 90523000, Руководство пользователя

Страница: 11 / 41

Installation 11
F I X T U R E O R I E N T A T I O N A N D L O C A T I O N
The FiberSource CMY150 can be installed in dry or damp locations.
Do not:
• Bury the FiberSource CMY150 or otherwise locate it in an unventilated space.
• Mount the FiberSource CMY150 on a wall in a vertical alignment. It may be
mounted horizontally (see “Fastening the FiberSource CMY150 to a structure” on
page 11).
• Install in wet locations.
Install the fixture in a location where it is:
• at least 0.5 meters (20 inches) away from the surface to be illuminated,
• at least 0.1 meter away from any combustible materials, and
• away from accidental public contact.
The fixture normally rests on the four plastic feet in its base.
F a s t e n i n g t h e F i b e r S o u r c e C M Y 1 5 0 t o a s t r u c t u r e
To fasten the FiberSource CMY150 to a structure:
1 Remove the fixture housing using a 5mm Allen wrench.
2 Separate the base plate from the fixture chassis by removing the 4 Hex screws using
a 5mm Allen wrench.
3 Remove the four plastic feet from the base using a cutting or clipping tool.
4 Ensuring that both the mounting hardware and the supporting structure are able to
bear the weight of the fixture, bolt the base plate to the structure using hardware that
will fit through the four 13mm (0.5 in) holes. Note that if you are attaching the fixture to
a ver tically-aligned structure such as a wall then the plate must be aligned
horizontally along its length (as in the following illustration).
Due to the restrictions of some lamps and the potential for water to enter the fixture
through the air filter, vertically-aligned mounting on a vertical surface such as a wall is
not recommended.
5 Re-attach the chassis to the base plate with the four Hex screws and a 5mm Allen
wrench.
6 Replace the fixture housing.