nature plate onto a pin in the right end of the plate holder. Release the plate holder clamp. Rotate the
signature plate shaft by hand backwards until the signature plate touches the platen from behind.
Slight contact between the signature plate and the platen prevents the signature plate from falling off
when the opposite signature plate is installed or removed. Install the second signature plate in the
same manner as the first. Ensure that both signature plates are seated properly, flat against the signa-
ture plate holder.
5.3
Installing the Ink Roller
X
Caution!! The ink roller is saturated with permanent ink. Always use the protective glove
supplied with your Model 911 (or similar hand protection) when working with ink
rollers.
Put the ink roller back onto the machine by first positioning the ink roller guide so that it straddles the
signature plate shaft, with the flat side of the ink roller guide at the top. Insert the ink roller shaft first
into one bracket, then the other. The springs inside the brackets hold the shaft in place. The ink roller
adjustment screws determine the inking of the signature plates.
5.4
Adjusting the Ink Roller
The depth of inking is adjusted at the factory. If readjustment is necessary, first rotate the signature
plate shaft so that a signature plate is facing the ink roller. Look in from the side to see the gap
between the signature plate and the ink roller. Adjust the screws with a crosspoint (Phillips)
screwdriver until the ink roller just contacts the rubber stamp evenly. Turn each screw one more turn
counterclockwise.
6.0 PROGRAMMING
Two features of the Model 911 can be programmed. One is the security codes, executive and operator,
that will allow the Model 911 to operate. The other feature is the stored forms, up to five. Each stored
form consists of the form size and a batch mode, either Count UP or Count DOWN. Choose Count UP
to have the Model 911 imprint forms until the paper is depleted. Choose Count DOWN to have the
Model 911 imprint a preset number of documents.
¤
In this manual, prompts and messages are shown in quotation marks, e.g., “Enter
Executive Code”.
To program, first turn on the 911. Then, insert the lock key into the key switch on the rear panel and
turn the lock key clockwise. Follow the prompt to select programming of either the “Security Codes”
or the “Stored Forms”.
6.1
Programming the Executive Security Code
When “Security Codes” is selected, the display will prompt “New Executive Code?”. To bypass pro-
gramming of the executive code, press ENTER at this time. To program the executive code, enter a 5-
digit number of your choice. Each digit entered will be acknowledged by moving the cursor in the
display. If a mistake is made, press CE and try again. After the fifth digit, the display will confirm
“New Executive Code Installed”.
6
