Marquis Crown Resort, Руководство пользователя

Страница: 8 / 57

INSTALLATION
LOCATION
For your portable spa to function properly and safely, it must be located on a hard, flat, level sur-
face. Inground spas require special installation techniques and should be planned in conjunction
with your authorized Marquis
®
dealer. Improper installation can result in structural damage to the
spa and the voiding of your spa warranty. Items to discuss with your dealer include: Local con-
struction codes, electrical service requirements, serviceability of equipment present underground
obstructions such as gas, water, and telephone lines, safety measures such as fences and locks,
and visibility of the spa installation from the home, street, and neighbors.
Do not shim your spa. If your pad is not level you must pour a top cap: contact a professional.
•
Allow for sufficient water drainage around the spa to help preserve the equipment and
support structure. This includes indoor installations.
• A filled spa can weigh over 5,000 pounds, excluding bathers and the location should support
the weight of the filled spa.
• Locate the equipment compartment where it will be accessible. Your spa MUST be installed
to permit access for servicing the equipment above and/or below any decks or floors.
Access is essential and must allow adequate room for service. To facilitate repairs, Marquis
Corp. or its agent may require access to spa equipment. It is your responsibility to provide
unencumbered access. See spa diagrams for location of power supply.
• Leave access to the circuit breakers in the sub panel (240V models) or to the interrupter
switch.
• Be sure the spa is level and in the final position BEFORE filling with water. Check for power
cords, tools, and hoses that may be caught underneath the spa. Do not apply power to the
spa before it is completely filled with water. Damage to the pumps, heater and sensors may
result.
• IMPORTANT: DO NOT LET AN EMPTY SPA REMAIN EXPOSED TO DIRECT SUNLIGHT.
Spa surface temperatures can reach in excess of 180°F (82°C) if left exposed to the sun.
Significant damage can occur to the acrylic if this is allowed to happen, including warp-
ing and blistering of the surface. Damage, that occurs as a result of this exposure, is not
covered under the warranty.
• CAUTION: Never try to move a spa that has not been fully drained. To do so could result
in damage to the spa and physical injury to the mover. Cracks in the spa surface, exterior
siding or DuraBase due to improper transport or support of the spa are not covered under
the warranty.
8