5
Wiring
White 2-Pin Connector
LED Status Indicator:
The LED indicator status should be mounted in a highly visible area such as top of the dashboard, on top of
the shifter console or on dashboard face. Leave at least 6mm space behind the mounting location for LED
housing. Once a suitable location is chosen, drill a 1/4" hole. Run the LED wires though the hole then press the
2-Pin LED housing into the place. Route the LED wires to the control module.
Black 4-Pin Connector
Two-Way Transceiver/Antenna Module:
The two-way transceiver/antenna mounts on the windshield
(Inside). We suggest you mount it on the lower left or upper left
side of windshield (driver’s side). Warning! Do not mount in
such a manner that it obstructs the drivers view.
• Remove the protective tape backing.
• Carefully align the two-way transceiver/antenna and apply to windshield.
• Route the black connector wire behind the trim and connect to the two-way transceiver/antenna.
• Connect the other end to the control module.
• Special considerations must be made for windshield glass as some newer vehicles utilize a metallic
shielded glass that will inhibit or restrict RF reception. In these vehicles, route the two way
transceiver/antenna module as far away as possible from metallic shielded glass.
Brown 3-Pin Connector
Optional Paging (Knock) Sensor:
The optional paging (knock) sensor can be added on.
1. Clean the bottom left side of the windshield.
2. Remove the protective backing from the adhesive tape or the back of the sensor.
3. Press the sensor firmly into place.
4. Hide the wire by carefully pushing it inside the space of the window’s mold trim.
5. To adjust the sensitivity of the sensor, turn the adjustment screw clockwise to increase sensitivity. Turn the
adjustment screw counter clockwise to decrease sensitivity.
Blue 2-Pin Connector
Valet Switch
Select a mounting location for the switch that is easily accessible to the driver of the vehicle. The switch does
not have to be concealed. However, concealing the switch is recommended, as this provides an even higher
level of security to the vehicle. Route the valet switch wires to the control module.
For best reception, we suggest
mounting the antenna horizontally.
M8A-IM.qxp 4/26/05 15:56 Page 5
