16
Alarm Feature Programming (Part 1)
Examine the 3 different feature charts enclosed and decide which feature will get changed. Circling the feature to
be changed will make the programming process much easier to perform.
To get into Alarm Feature Programming Mode (Part 1), repeat the following procedure:
Turn the ignition switch from the OFF position to the ON
position 3 times leaving it in the OFF position the third
time.
Before 15 seconds has passed, push and release the valet
switch one (1) time then push the valet switch a second
time and hold it in on until 1 short and 1 long chirp or
beep is heard, then release it. You are now in Alarm
Feature Programming Part 1 programming mode.
Step 1
Step 2
OFF
ON
3X
1X + 1X (Hold)
Turn the ignition switch from the OFF position to the ON
position 3 times leaving it in the ON position the third
time.
Before 15 seconds has passed, push and release the valet
switch two (2) times then push the valet switch a third time
and hold it in on until a long chirp or beep is heard then
release it. You are now in transmitter programming mode.
Step 1
Step 2
OFF
ON
3X
2X + 1X (Hold)
Step 3
Press the “Lock” button on the first
transmitter until you hear a confir-
mation chirp/beep. The transmitter is
now coded into the system.
Step 4
Repeat for each additional transmitter.
Step 5
When finished, either turn off the
ignition key or wait for 15 seconds
to get out of transmitter program-
ming mode. You will hear three (3)
long chirp/beeps to indicate you are
out of the transmitter programming
mode.
OFF
Programming the Transmitter
Programming the Remote Transmitter
Important Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory
is exceeded, the security system will start deleting transmitters from memory in chronological order.
M8A-IM.qxp 4/26/05 15:56 Page 16
