14
0 = hand-off function off, Back-EMF off
1 = hand-off function on, Back-EMF off
2 = hand-off function off, Back-EMF on
3 = hand-off function on, Back-EMF on Hand-off function on:
When operating with 55015, you can adjust direction and
speed for two seconds after selecting a moving loco without
causing the loco to stop.
CV55
Reset of most programmed CVs
55 = most important CVs are reset to the factory pre-set values
CV60
Back-EMF: Max. adjustment factor (0: small, 255: large)
(1..255)
[48]
Specifies the max. increase or decrease of voltage applied
during each time interval (programmed in CV61)
Attention!
The factory pre-set values of CV60 and CV61 are
optimized for LGB motors.
CV61
Back-EMF: Adjustment frequency (0: often, 255: seldom)
(0..255)
[0]
Specifies how often per second the motor voltage is adjusted -
accordingly, the loco will react to curves and grades immediately
or with a short delay
CV62
Back-EMF: Max. Adjustment (0: small, 255: max.)
(0..255)
[255]
Limits the total adjustment in motor voltage. If there is a very
large load on the motor, the adjustment will not exceed this
value - for more realistic operations, so that locos will slow a
bit on grades.
CV67
Speed steps programmed by user (see CV29):
(0..255)
to
28 speed steps are programmed in CV67 to CV94.
CV94
With LGB MTS, every second value is skipped (14 speed steps).
Factory pre-set speed steps:
7, 9, 11, 13, 16, 20, 24, 28, 32, 36, 42, 48, 54, 60, 68, 76, 84,
92, 102, 112, 124, 136, 152, 168, 188, 208, 230, 255
Pre-set values for user-programmable speed steps:
8, 16, 24, 32, 40, 48, 56, 64, 72, 80, 88, 96, 104, 112, 120, 128,
136, 144, 152, 160, 168, 176, 184, 192, 208, 224, 240, 255
Hint:
The speed steps are factory pre-set and programming is
not necessary. Use the 55045 MTS PC Decoder Programming
Module for programming.
