Mark-10 ME-100, Руководство пользователя

Страница: 12 / 26

Series E Ergonomics Force Gauges User’s Guide
11
2. Averaging occurs only while above the trigger force. As the force drops back down to this trigger,
averaging stops. To enable this function, scroll to Stop at Force and press ENTER .
Select
Settings to configure Trigger Force , Initial Delay , and Averaging Time :
Parameter Description
Trigger Force
or
Start / Stop Force
The minimum force required to start the averaging sequence. Toggle between
compression and tension directions by pressing the
DIRECTION key. Initial delay
follows the trigger force. If Stop at Force is enabled, this parameter is referred to
as Start / Stop Force , denoting the minimum force for which averaging will be
active.
Initial Delay
The time delay, after the trigger force, before the averaging sequence
commences.
Available settings: 0.0 – 300.0 sec., in 0.1 sec. increments
Averaging Time
The time duration of the averaging sequence. This setting is ignored when Stop
at Force is enabled, unless the 300 sec. limit is reached.
Available settings: 0.1 – 300.0 sec., in 0.1 sec. increments
After the parameters have been configured and the menu has been exited, press
MODE until AVG is
displayed. Then press ZERO . Average mode is now armed, and the averaging sequence will commence
when the trigger force has occurred. The current status of the averaging sequence is displayed below the
primary reading, as follows:
Step Status Description
1 TRIG WAIT The trigger force has not yet occurred.
2 INIT DLY The initial delay is currently taking place.
3 AVERAGING The gauge is collecting readings. The status will be flashing until averaging has
been completed.
4 AVRG DONE Averaging has been completed. The average force is displayed in the primary
reading.
AVERAGE MODE SETTINGS
Trigger Force
1.00 lbF
Initial Delay
1.0 sec.
Averaging Time
5.0 sec.
www. .com
information@itm.com 1.800.561.8187