MARIMEX Orlando Premium 10310019, Руководство по сборке

Страница: 94 / 144

94
EN
• All underlying blocks must be recessed so that their upper surfaces are flush
with the compacted bottom of the pool.
• Using a spirit level, make sure that the underlying blocks are perfectly level
and level with the ground (Figure 2A-12 A = Putting layer at the bottom of the
trench, B = Base block, C = Excavation). With spirit level on a 5x10 cm prism, make
sure that the top surfaces of the adjacent base blocks are in one plane. After all
the blocks have been laid, sand them with sand or crushed aggregate (Fig. 2A-13
A = Obsyp). Compress the dump.
• To increase the stiffness of the substrate, the substrate can be used
place the blocks under sloping struts in the concrete laying layer. The excavation
must be roughly twice deeper than the thickness of the paving block used and
about 5 cm wider than the block on each side. Use concretes for both the laying
layer and the obsyp.
IMPORTANT: Level the base blocks to the plane between them as described in step
• Before the concrete hardens. Before continuing to build the pool, wait until the
concrete has become sufficiently stiff.
• Remove all measuring pins. Keep the poles in place to check the dimensions
during construction.
WARNING: Ensure adequate drainage of the area around the pool to avoid sub-
straction.
Continue in mounting in part 3A of the instruction
Part 2B – Preparation of the base for the circular
swimming pool
IMPORTANT: The area under the pool must meet the following essential condi-
tions:
It must be horizontal, ie. within a tolerance of not more than 2.5 cm to the tran-
sverse dimension of the pool.
It must be provided with a thin layer of sifted sand, ie. (sandeel, hoe, ...) to cover
the entire area of the pool with a layer of not more than 2 cm.
It must be compacted, ie. so strong that a person weighing at least 80 kg does not
leave a visible trace on the surface.
Click the plate
• Push the pin into the intended center of the pool (Figure 2B-1).
• Think of one end of a string as a pin, and on the other end, consider a can with
sand or lime, flour, etc., which is marked on the ground by a circle. The radius
of the circle will be 15 cm larger than the radius of the pool (Figure 2B-2). The
length of the string and prism is 250 cm for a 4.6 m diameter swimming pool.
Remove dry
• Carefully remove all debris and plants from the marked area to a depth of 10-
15 cm (Figure 2B-3).
• Remove all sticks, stones and roots from the marked area.
• If the pool is to be poured into the ground, excavation work must be done in
depth according to a special construction.